Aruba RAP-155 - Instant CLI; What Is New in this Release

15 | About Aruba Instant Aruba Instant 6.5.0.0-4.3.0.0 | User Guide
Instant CLI
The Instant Command Line Interface (CLI) is a text-based interface that is accessible through a Secure Shell
(SSH) session.
SSH access requires that you configure an IP address and a default gateway on the IAP and connect the IAP to
your network. This is typically performed when the Instant network on an IAP is set up.
What is New in this Release
The following features are introduced in Instant 6.5.0.0-4.3.0.0:
Feature Description
New Option Added for
Broadcast Filtering
A new option called Unicast-ARP-Only has been added to broadcast filtering. This option
converts the ARP requests to unicast frames and sends them directly to the associated
clients.
Media Classification
Techniques for Voice
and Video
Enabling Enhanced Voice
Call Tracking
Starting from Instant 6.5.0.0-4.3.0.0, IAP supports media classification for Skype for
Business and Apple Facetime.
Voice and Video calls can be prioritized by the following media classification types:
l Classifying voice and video calls by using an ACLwith the classify-media option
enabled
l STUNbased media classification
The Master IAP sends an SNMP trap to the third-party SNMP server with the location
details of the VoIP caller.
Configuring Maximum
Clients on SSIDRadio
Profiles
The maximum number of clients allowed to connect to a WLANSSIDRadio profile can
now be individually set using the Instant CLI.
Redirect Blocked
HTTPSWebsites to a
Custom Page URL
Instant 6.5.0.0-4.3.0.0 allows you to redirect blocked HTTPS websites to a custom page
url by configuring the Redirect-Blocked-HTTPSrule type for WLANSSIDand wired
profiles.
Configuring Security
Settings for a Wired
Profile
Instant supports the trusted ports in an IAP to enable wired users on a Layer-3 mode to
connect to a switch or a router which is connected to the downlink port of the IAP. A new
parameter called Port type is introduced in the wired profile of the Instant UI. IAPs can
now manage incoming traffic received from the clients.
UI support for Enet-VLAN
Setting
A new system parameter Uplink switch native VLAN which is introduced in the
Instant UI restricts the IAP from sending out tagged frames to clients connected on the
SSID that has the same VLAN as the native VLAN of the upstream switch, to which the
IAP is connected.
ARM Channel Selection IAPs can trigger a radio profile to perform frequent scanning and selection of a valid
channel in a short span of time. A new command, ap-frequent-scan enables the IAPs to
frequently scan signals in the radio profile.
Table 5: New Features