Aruba RAP-155 - Firewall Support for Ipv6; Debugging Commands; SNTP over Ipv6

SNTPOver IPv6
To view the SNTP configuration:
(Instant AP)# show running-config|include ntp
ntp-server 2001:470:20::121
Firewall Support for IPv6
For a given client, a single ACLis used to firewall both IPv4 and IPv6 rules. A rule any any match any any
any permit in the access rule configuration will expand to two different ACL entries:
l any any any P6
l any any any P4
Similarly, if any IPv6 specific rule is added. For example, if any DHCPv6 or FTPv6 rule is added, the ACE would
be expanded as follows:
any 2002::/64 17 0-65535 546-547 6—destined to network 2002::/64 DHCPv6 is denied.
any 2001::10/128 6 0-65535 20-21 6—destined to host 2001::10 FTP is denied.
For all ACLs the IAP will have an implicit IPv4 and IPv6 allow all acl rule.
Debugging Commands
Use the following commands to troubleshoot issues pertaining to IPv6 configuration:
l show ipv6 interface brief and show ipv6 interface details— displays the configured IPv6 address,
and any duplicate addresses.
l show ipv6 route—displays the IPv6 routing information.
l show datapath ipv6 session—displays IPv6 sessions.
l show datapath ipv6 user—displays IPv6 client details.
l show clients and show clients debug—displays the details about IAP clients.
Aruba Instant 6.5.0.0-4.3.0.0 | User Guide IPv6 Support | 80