260 | Adaptive Radio Management Aruba Instant 6.5.0.0-4.3.0.0 | User Guide
5.0 GHz Channels
----------------
Channel Status
------- ------
36 enable
40 enable
44 enable
48 enable
52 enable
56 enable
60 enable
64 enable
149 enable
153 enable
157 enable
161 enable
165 enable
36+ enable
44+ enable
52+ disable
60+ disable
149+ enable
157+ enable
36E enable
52E enable
149E enable
Configuring Radio Settings
You can configure 2.4 GHz and 5 GHz radio settings for an IAP either using the Instant UI or the CLI.
In the Instant UI
To configure radio settings:
1. Click the RF link located directly above the Search bar of the Instant main window.
2. Click Show advanced options. The advanced options are displayed.
3. Click the Radio tab.
4. Under the channel 2.4.GHz or 5 GHz, or both, configure the following parameters.
Parameter Description
Legacy only
Select Enabled to run the radio in non-802.11n mode. This option is set to Disabled by
default.
802.11d / 802.11h
Select Enabled to allow the radio to advertise its 802.11d (Country Information) and
802.11h (Transmit Power Control) capabilities. This option is set to Disabled by default.
Beacon interval
Enter the Beacon period for the IAP in milliseconds. This indicates how often the 802.11
beacon management frames are transmitted by the access point. You can specify a value
within the range of 60-500. The default value is 100 milliseconds.
Interference
immunity level
Select to increase the immunity level to improve performance in high-interference
environments.
Table 57: Radio Configuration Parameters
To Next Page
Loading...
