363 | Monitoring Devices and Logs Aruba Instant 6.5.0.0-4.3.0.0 | User Guide
Engine ID:D8C7C8C44298
Community Strings
-----------------
Name
----
SNMPv3 Users
------------
Name Authentication Type Encryption Type
---- ------------------- ---------------
SNMP Trap Hosts
---------------
IP Address Version Name Port Inform
---------- ------- ---- ---- ------
Configuring SNMP Traps
Instant supports the configuration of external trap receivers. Only the IAP acting as the VC generates traps. The
traps for IAP cluster are generated with VC IP as the source IP, if VC IP is configured. The Object Identifier (OID)
of the traps is 1.3.6.1.4.1.14823.2.3.3.1.200.2.X.
You can configure SNMP traps by using the Instant UI or the CLI.
In the Instant UI
To configure an SNMP trap receiver:
1. Navigate to System > Show advanced options > Monitoring.
2. Under SNMP Traps, enter a name in the SNMP Engine ID text box. It indicates the name of the SNMP
agent on the IAP. The SNMPv3 agent has an engine ID that uniquely identifies the agent in the device and is
unique to that internal network.
3. Click New and update the following information:
l IP Address—Enter the IP Address of the new SNMP Trap receiver.
l Version—Select the SNMP version— v1, v2c, v3 from the drop-down list. The version specifies the
format of traps generated by the access point.
l Community/Username—Specify the community string for SNMPv1 and SNMPv2c traps and a
username for SNMPv3 traps.
l Port—Enter the port to which the traps are sent. The default value is 162.
l Inform—When enabled, traps are sent as SNMP INFORM messages. It is applicable to SNMPv3 only. The
default value is Yes.
4. Click OK to view the trap receiver information in the SNMP Trap Receivers window.
In the CLI
To configure SNMP traps:
(Instant AP)(config)# snmp-server host <IP-address> {version 1 | version 2 | version 3} <name>
(Instant AP)(config)# end
(Instant AP)# commit apply
Instant supports SNMP Management Information Bases (MIBs) along with Aruba-MIBs. For information
about MIBs and SNMP traps, refer to the Aruba Instant 6.5.0.0-4.3.0.0 MIB Reference Guide.
To Next Page
