To display the banner:
(Instant AP)# show banner
The loginsession command configures the management session (Telnet or SSH) to remain active without any
user activity.
To define a timeout interval:
(Instant AP) (config) #loginsession timeout <val>
<val> can be any number of minutes from 5 to 60, or any number of seconds from 1 to 3600. You can also
specify a timeout value of 0 to disable CLI session timeouts. The users must re-login to the IAP after the session
times out. The session does not time out when the value is set to 0.
Aruba Instant 6.5.0.0-4.3.0.0 | User Guide Setting up an IAP | 26
To Next Page
Loading...
