347 | Spectrum Monitor Aruba Instant 6.5.0.0-4.3.0.0 | User Guide
3. Click the Radio tab.
4. From the Access Mode drop-down list, select Spectrum Monitor.
5. Click OK.
6. Reboot the IAP for the changes to take effect.
7. To enable spectrum monitoring for any other band for the 5 GHz radio:
a. Click the RF link on the Instantmain window.
b. In the RF section, click Show advanced options to view the Radio tab.
c. For the 5 GHz radio, specify the spectrum band you want that radio to monitor by selecting Lower,
Middle, or Higher from the Standalone spectrum band drop-down list.
d. Click OK.
In the CLI
To convert anIAP to a spectrum monitor:
(I
ns
ta
nt
AP
)#
wi
fi
0-
mo
de
{
<acc
ess>
|
<m
onit
or>
|
<
spec
trum
-mon
ito
r>
}
(I
ns
ta
nt
AP
)#
wi
fi
1-
mo
de
{
<acc
ess>
|
<m
onit
or>
|
<
spec
trum
-mon
ito
r>
}
To enable spectrum monitoring for any other band for the 5 GHz radio:
(Instant AP)(config)# rf dot11a-radio-profile
(Instant AP)(RF dot11a Radio Profile)# spectrum-band <type>
To view the radio configuration:
(Instant AP)# show radio config
2.4 GHz:
Legacy Mode:disable
Beacon Interval:100
802.11d/802.11h:disable
Interference Immunity Level:2
Channel Switch Announcement Count:0
Channel Reuse Type:disable
Channel Reuse Threshold:0
Background Spectrum Monitor:disable
5.0 GHz:
Legacy Mode:disable
Beacon Interval:100
802.11d/802.11h:disable
Interference Immunity Level:2
Channel Switch Announcement Count:0
Channel Reuse Type:disable
Channel Reuse Threshold:0
Background Spectrum Monitor:disable
Standalone Spectrum Band:5ghz-upper
To Next Page
Loading...
