383 | Hotspot Profiles Aruba Instant 6.5.0.0-4.3.0.0 | User Guide
Parameter Description
group-frame-block Enable this parameter if you want to stop the IAP from sending forward downstream
group-addressed frames.
hessid Specify a Homogenous Extended Service Set Identifier (HESSID) in a hexadecimal format
separated by colons.
internet Specify this parameter to allow the IAP to send an Information Element (IE) indicating that
the network allows Internet access.
p2p-cross-connect Specify this parameter to advertise support for P2P cross-connections.
p2p-dev-mgmt Specify this parameter to advertise support for P2P device management.
pame-bi Specify this parameter to enable Pre-Association Message Exchange BSSID Independent
(PAME-BI) bit, with which the IAP can indicate that the Advertisement Server can return a
query response independent of the BSSID used in the GAS Frame exchange.
query-response-
length-limit
Specify this parameter to set the maximum length of the GAS query response, in octets.
You can specify a value within the range of 1–127. The default value is 127.
roam-cons-len-1
roam-cons-len-2
roam-cons-len-3
Specify the length of the organization identifier (OI). That is, the value for the length of OIs
of roam-cons-len-1, roam-cons-len-2, or roam-cons-len-3. The roaming consortium OIis
based on the following parameters:
l 0: Zero Octets in the OI (Null)
l 3: OI length is 24-bits (3 Octets)
l 5: OI length is 36-bits (5 Octets)
venue-group Specify one of the following venue groups
l unspecified
l assembly
l business
l educational
l factory-and-industrial
l institutional
l mercantile
l outdoor
l residential
l storage
l utility-misc
l vehicular
By default, the business venue group is used.
venue-type Specify a venue type to be advertised in the ANQP IEs from IAPs associated with this
hotspot profile. For more information about the supported venue types for each venue
group, see Table 80.
Table 81: Hotspot Profile Configuration Parameters
To Next Page
