Aruba RAP-155 - Page 64

Parameter Description
CLI Configuration
When Auto-Join feature is disabled, the inactive IAPs
are displayed in red.
(Instant AP)(config)
# allow-new-aps
Terminal access When terminal access is enabled, you can access
the IAP CLI through SSH.
The terminal access is enabled by default
(Instant AP)(config)
# terminal-access
Console access When enabled, you can access the IAP through the
console port.
(Instant AP)(config)
# console
Telnet server
To start a Telnet session with the IAP CLI, enable
access to the Telnet server.
(Instant AP)(config)
# telnet-server
LED display
LEDdisplay status of the IAP. To enable or disable
LEDdisplay for all IAPs in a cluster, select Enabled
or Disabled, respectively.
NOTE: The LEDs are always enabled during the IAP
reboot.
(Instant AP)(config)
# led-off
Extended SSID
Extended SSID is enabled by default in the factory
default settings of IAPs. This disables mesh in the
factory default settings.
l The RAP-108/109 access points support up to 6
SSIDs with Extended SSID disabled and up to 8
SSIDs with Extended SSID enabled.
l All other IAPs support up to 14 SSIDs when
Extended SSID is disabled and up to 16 SSIDs
with Extended SSID enabled.
(Instant AP)(config)
# extended-ssid
Table 17: System Parameters
Aruba Instant 6.5.0.0-4.3.0.0 | User Guide Initial Configuration Tasks | 64