Dispensing Batches
88 FastPak EXP Operating Manual
6. Click Continue.
Note
If you un-select Check Expiration Date Within X Days
on the Dispense window shown in Figure
7-3, the
system will not check expiration dates, and the
indication of low count medications will not appear.
Note
If the FastPak EXP hardware does not respond, check
the front panel. Press Start if the display reads “System
Stop”; the device will then start dispensing. If it says
“Heater Alarm” the device is not yet at operating
temperature. Wait until the message on the front panel
changes before dispensing.
When using prefill trays, follow these steps:
Note
You must check the Tray Prefill option in the FastPak
EXP settings to use the prefill tray functionality. See
page
110.
1. Click Prefill Trays on the Fill Tray window
shown in Figure
7-12. The Tray Fill List tab
window appears.
2. Click Print to print the tray fill report.
3. Click Prefill Trays. The Tray Fill Verify window
appears.
4. Scan the barcode on the bottom of the report.
To Next Page
Loading...