12:34
Accept Reject
010
Fire alert in
building A...
TD 92477EN
8 April 2016 / Ver. M
User Manual
Ascom d62 DECT Handset
55
Figure 10. Incoming Invitation Received as a Message
1 Press "Accept".
The handset may accept the invitation autom
atically, start in inverted mute and
loudspeaking mode, depending on the configuration of the received invitation.
When the invitation is accepted, the following screen appears (see figure 11). The invitation
can now be deleted or closed by clicking the soft key Delete or
Close, respectively. The call is
not disconnected by clicking these soft keys. The soft key Call is used for re-joining a group
only, see 8.2.8 Re-join a Group on
page 56.
12:34
Call Close
011
Fire alert in
building A...
Delete
Figure 11. Accepted PTT Invitation
2Press and hold
to open the microphone for transmitting. The microphone is
muted again when
is released.
NOTE: In the d62 Messenger handset, the mult
ifunction button may have also been
configured to act as the
button.
Invitation Received as Message during
an Ongoing Call
If a user receives an invitation durin
g an ongoing call, the call is disconnected and the PTT
call connected if the following conditions apply:
• The handset is configured to answer invita
tions automatically
• The invitation is of higher priority tha
n the call priority
• The user does not reject the invitation within 10 seconds
When the invitation is received, a warning signal notifies th
e user before disconnecting the
current call in order to connect the PTT call.
NOTE: Depending on the priority of the invitation
, the ongoing call might be disconnected
immediately or after 10 seconds.
To Next Page
Loading...
Need help?
General
