ASCOM D62 User Manual

TD 92477EN
8 April 2016 / Ver. M
User Manual
Ascom d62 DECT Handset
80
Error or Warning Messages
Display shows Probable cause Action or comment
No access The network is in range, but no
access rights.
Switch handset off and then
switch it on again or contact
system administrator.
No System. The handset
beeps once a minute
(during max 30
minutes) with a low
tone followed by a high
tone (if enabled, the
vibrator also follows the
beeps).
The handset is out of coverage or
handset is defective.
Stop the beep with the Sound
off key and go into range.

Note: When re-entering the
coverage area it can take a
couple of minutes before the
handset automatically has
registered into the system.
or contact system
administrator.
The message Failed is
displayed when the
handset tries to
download an ECG
waveform image.
The IP-DECT wireless connection
point is overloaded with too many
calls.
Go see the patient. The ECG
Monitoring functionality starts
working when the IP-DECT
connection point is no longer
overloaded.
SERVICE NEEDED
Parameters corrupt
Note: This display
message is only shown
in English.
The handset is defective. Select the reset option on the
middle soft key and upgrade
the handset’s software to
version 3.0.0 or greater. If this
is not available or the problem
persists send the handset for
service.
SERVICE NEEDED
Invalid IPDI
Note: This display
message is only shown
in English.
Easy replacement procedure not
followed correctly or failure during
easy replacement procedure.
Send the handset for service.
Enter PIN code The handset’s lock is activated. Enter the required PIN code. If
PIN code lost enter new via PDM
or do a factory reset via PDM.
Battery low, charge now The battery level is low. Charge or replace the battery.
Phonebook is not
available at the
moment.
The phonebook does not respond,
not available at the moment.
Try again later or if fault
persists do a factory reset via
admin menu or PDM.
Voicemail number not
defined
There is no Voicemail number
defined in the handset.
Define a Voicemail number via
PDM.
Could not encrypt
connection
The parameter "Encryption
Required" is enabled in the
handset in combination with;

ASCOM D62 Specifications

General

Brand	ASCOM
Model	D62
Category	Handsets
Language	English