ASCOM D62 User Manual

TD 92477EN
8 April 2016 / Ver. M
User Manual
Ascom d62 DECT Handset
81
LED Error Indications
See also chapter LED Indications during Easy Replacement on page 86.
LED is flashing red, quick flash, (100 ms on, 800 ms off)
1) If a third handset, that is another handset than the "old" (the replaced handset) and
"new" (the replacement handset) handset, is inserted into the charger during Easy
Replacement, this error indication appears. Change to the correct handset.
2) The charger has found that Easy Replacement does not work. Change back to the "new"
handset.
LED is flashing red, long flash (800 ms on, 100 ms off)
Error during Easy Replacement. Both telephones need to be sent for service.
1) Unencrypted base station(s);
and/or,
1) Disable the "Encryption
Required" parameter in
handset; and/or,
2) Unsupported base station(s). 2) Enable the encryption in the
base station(s); and/or,
Note: If Ascom’s base station(s)
is used, the software version
must be 3.1.x or greater.
3) Use supported base
station(s). Ask your supplier.
Not allowed 1) The user cannot login to the
handset with the shared phone
functionality enabled, due to
another handset currently using
the same extension (User).
1) Logout from the handset
that uses the same extension.
2) The user cannot logout from
the handset with the shared
phone functionality enabled, due
to incorrect password (AC code).
2) Enter #11*<AC code># on
the keypad and press the off-
hook key to logout from the
shared phone.
3) The extension (User) does not
exists.
3) Make sure that you entered
correct extension. If needed,
contact the system
administrator.
4) The password is not correct. 4) Make sure that you have
entered correct password. Ask
the system administrator if you
have forgot the password.

ASCOM D62 Specifications

General

Brand	ASCOM
Model	D62
Category	Handsets
Language	English