Automated Logic OptiFlex G5CE

To Next Page

To Previous Page

Verify that you have the most current version of this document. Go to the Automated Logic® Partner

Community website to download it.

Important changes are listed in Document revision history at the end of this document.

A Carrier Company

Main Page

Table of Contents3
What Is the Optiflex™ Bacnet Integrator (Part No. G5CE)5
Critical Product Announcement6
Specifications6
Zone Sensors9
Touchscreen Devices9
To Mount the G5CE10
Wiring for Power11
To Wire for Power12
Addressing the G5CE12
To Set up Autobaud13
To Set the IP Address14
To Set the Port S1 Address and Baud Rate16
To Set the Port S2 Address and Baud Rate16
Wiring for Communications17
Wiring Specifications17
To Connect the G5CE to the Ethernet18
To Wire to a Bacnet/Arcnet Network18
To Wire to a Bacnet MS/TP Network18
To Wire a Third-Party Device19
Wiring Devices to the G5Ce's Rnet Port19
To Communicate through the Bacnet/Ip Service Port Network19
Downloading the G5CE20
To Download from the Webctrl® Interface21
Adjusting the G5CE Driver Properties21
Driver21
Device23
Notification Classes23
Calendars24
Common and Specific Alarms25
Bacnet Router Properties26
Bacnet Firewall27
Network Diagnostics - Statistics28
Network Diagnostics - Packet Capture30
Communication Status31
To Set up Network Statistic Trends32
To Set up the Controller through the Service Port33
Modstat Tab33
Device Tab34
Ports Tab35
Bacnet Tab35
Modbus Tab37
Security Tab37
To Communicate Locally through the Rnet Port38
To Set up a Local Access Connection in the Webctrl® Interface39
Troubleshooting40
Leds40
To Get a Module Status Report42
To Get a Device Log43
To Get the G5Ce's Serial Number43
To Replace the G5Ce's Fuse43
To Take the G5CE out of Service44
To Revert to Default Settings45
Compliance46
FCC Compliance46
CE and UKCA Compliance46
Industry Canada Compliance46
Bacnet Compliance46
Appendix - Module Status Field Descriptions47
Document Revision History49

Automated Logic OptiFlex G5CE

Table of Contents