Automated Logic OptiFlex G5CE User Manual

OptiFlex™ BACnet Integrator (part no. G5CE) Automated Logic Proprietary and Confidential A Carrier Company. © 2022 Carrier.
Rev. 6/9/2022 All rights reserved.
21
Common and Specific Alarms
On these pages, you can enable/disable, change BACnet alarm properties, or set delays for the
following BACnet alarms:
Common alarms:
Specific alarm:
• All Programs Stopped
• Excessive COV
• Program Stopped
• Locked I/O
• Controller Halted
• Control Program
• Duplicate Address
• Dead Controller Timeout
NOTE To set up alarm actions for controller generated alarms, see Setting up alarm actions in the
WebCTRL® Help.
Controller Generated
Alarm
Description
Short message shown on the Alarms page or in an alarm action when
this type of alarm is generated.
Events
Alarm Category and
Alarm Template
See Customizing alarms in WebCTRL® Help.
Enable
Clear these checkboxes to disable Alarm or Return to normal messages
of this type from the G5CE.
Notification Class
In a typical WebCTRL® system, the Notification Class is 1; however, if
needed, you can associate a different notification class with the alarm.
See Notification Classes (page 19) to set up alarm delivery options for a
specific Notification Class.

Automated Logic OptiFlex G5CE Specifications

General

Brand	Automated Logic
Model	OptiFlex G5CE
Category	Network Hardware
Language	English