101
Installing an Avaya SCC1 Media Gateway Stack
October 2002
Perform these tasks before you begin the installation:
• ‘‘Unpack and Inspect Media Gateways’’ on page 101
• ‘‘Unpack and Inspect Stratum 3 Clock Cabinet’’ on page 129
• ‘‘Check Circuit Packs’’ on page 102
• ‘‘Correct Shipping Errors’’ on page 67
Perform these steps to install the media gateways:
• ‘‘Position the Media Gateway Stacks’’ on page 103 or ‘‘Position the Auxiliary Cabinet
(Optional)’’ on page 67
• ‘‘Install Earthquake Protection for Avaya SCC1 Media Gateway’’ on page 103 (if
required)
!
WARNING:
S8700 Multi-Connect configuration grounding must comply with the general rules for
grounding contained in Article 250 of the National Electrical Code (NEC), National Fire
Protection Agency (NFPA) 70, or the applicable electric code in the country containing the
equipment.
• ‘‘Ground DC power media gateways’’ on page 106 and ‘‘Connect DC Power’’ on page
110 or ‘‘Ground and Connect AC-Powered Media Gateways’’ on page 117
• ‘‘Connect Time Division Multiplexing Bus Cables’’ on page 119
• ‘‘Verify Port Media Gateway Address Plugs’’ on page 121
• ‘‘Install Rear Panels’’ on page 122
• ‘‘Install Rear Ground Plates (Media Gateways with Earthquake Protection)’’ on page
123 or ‘‘Install Front Ground Plates (Media Gateways with Radiation Shielding and
Earthquake Protection)’’ on page 124 or ‘‘Install Media Gateway Clips (Media
Gateways without Earthquake Protection)’’ on page 126
• ‘‘Connect S8700 Multi-Connect configuration Cables’’ on page 127
1 Check the customer’s order and the shipping packing lists to confirm all equipment is
present.
2 Check the S8700 Multi-Connect configuration adjuncts for damage and report all
damage according to local shipping instructions.
3 If any equipment is missing, report the information to your Avaya representative.
Unpack and Inspect Media Gateways
!
CAUTION:
Lifting the media gateway requires two people, as it may weigh as much as 130 pounds
(60 kilograms). Use caution to avoid injury.
To Next Page
Loading...
