126
Installing an Avaya SCC1 Media Gateway Stack
October 2002
Install Media Gateway Clips (Media Gateways
without Earthquake Protection)
A media gateway clip is required between each pair of stacked media gateways.
At the front of the media gateways, install a media gateway clip between each pair of media
gateways by hooking the clip into the slot of the upper media gateway and snapping the straight
leg of the clip into the slot on the lower media gateway. See ‘‘Location of Media Gateway
Clips’’ on page 126.
Location of Media Gateway Clips
Figure notes
1 Expansion Control Media Gateway A
2 Port Media Gateway B
3 Port Media Gateway C
4 Port Media Gateway D
5 Media Gateway Clips
To Next Page
Loading...
