177
Patch Cord/Jumper Installation and Administration
October 2002
Example 4-Pair Labeling to Information Outlet
Label Expansion Control Carrier Cable
1 Place the appropriate AUX connector label on the assigned 110-type terminal block row.
2 On the expansion control carrier cable, place a yellow auxiliary label on the connectors
at each end of the cable.
3 Write “AUX” on each label.
Connect Expansion Control Carrier Outputs Cable
‘‘Installing the Telecommunications Cabling’’ on page 142
Figure notes
1 Equipment Room
2 To Central Location for Terminals 1
through 6
3 Blue Row on 110 Terminal Block
4 Purple Row on 110 Terminal Block
5 To Port Connector on Media Gateway
(Media Gateway 1, Carrier A, Slot 03)
6 258A Adapter
7 D-Inside Wire Cut Down to
Connecting Block
8 Information Outlet
9 Voice Terminal
crdf4pr CJL 102996
To Next Page
Loading...
