227
Connecting to the Customer’s Network
October 2002
• In the Node Name field type the same node name entered on the Node Name
screen.
• In the Subnet Mask field use the default setting unless you are given a different
subnet mask.
• In the Gateway Address field use the address you are given or leave blank.
• Set the Net Region field to 1 unless you are given a different number.
• Set the Enable Eth Pt field to y
7 Press Enter to save the information and effect the new settings.
Refer to the Administration for Network Connectivity for Avaya MultiVantage Software for
more information on these administration steps and for the steps to administer IP Softphones
and H.323 trunks.
Test the External Connection to the LAN
To test the external IP connections, ping the IP Media Processor server and ping a known
computer connected to the network. If everything is configured correctly, the Result column
on the Ping Results screen reads pass. If it reads abort, verify the IP address information and
check the connectivity, including the cabling.
1 Type ping ip-address IPaddress board UUCSS and press Enter. The variable IPaddress
is the IP address of the TN2302AP IP Media Processor and UUCSS is the cabinet,
carrier, and slot of the TN2302AP IP Media Processor.
2 Type ping ip-address IPaddress board UUCSS and press Enter. The variable IPaddress
is the IP address of the customer’s gateway and UUCSS is the cabinet, carrier, and slot of
the TN2302AP IP Media Processor.
3 Type ping ip-address IPaddress board UUCSS and press Enter. The variable IPaddress
is the IP address of another computer beyond the gateway and UUCSS is the cabinet,
carrier, and slot of the TN2302AP IP Media Processor.
The TN2302AP IP Media Processor is now installed in the media gateway and connected to the
IP network.
ping ip-address 192.168.10.21
PING RESULTS
End-pt IP Port Port Type Result Time(ms) Error Code
192.168.10.21 01A13 MEDPRO PASS 10 1124
To Next Page
Loading...
