230
Connecting to the Customer’s Network
October 2002
Installing VAL
NOTE:
To install a TN2501AP, make sure that the system is enabled for TN2501AP (VAL)
boards. If the Maximum VAL boards field on the Customer Options screen is set to 0,
then you need to obtain and install a new license file before you can install the card.
Installing the pack includes:
• ‘‘Verifying the required hardware’’ on page 230
• ‘‘Install the TN2501AP Circuit Pack’’ on page 232
• ‘‘Administer the TN2501AP’’ on page 233
Verifying the required hardware
Make sure that you have the required hardware:
• TN2501AP VAL circuit pack (108772583). See ‘‘Faceplate of VAL circuit pack’’ on
page 231.
• 10/100BaseT backplane adapter (848525887—same one used for the IP Media
Processor). See ‘‘Backplane Adapter’’ on page 232
.
• LAN cable with RJ45 connectors (customer supplied).
To Next Page
Loading...
