215
Connecting to the Customer’s Network
October 2002
Connecting to the Customer’s
Network
The S8700 Media Server for IP Connect and Multi-Connect Configurations and other
components connect directly to the customer’s network. The following sections provide
installation, administration, and test information for various IP components.
• ‘‘Avaya™ S8700 Media Server’’ on page 215
• ‘‘TN799DP Control LAN’’ on page 216
• ‘‘The TN2302AP IP Media Processor’’ on page 222
• ‘‘The TN801B MAP-D LAN Gateway’’ on page 228
• ‘‘TN2501 Voice over the LAN (VAL)’’ on page 229
• ‘‘Avaya R300 Remote Office Communicator’’ on page 237.
Avaya™ S8700 Media Server
In a typical configuration you connect to the network through a port on the back of the Avaya™
S8700 Media Server, using a standard CAT5 cable with RJ45 connectors on each end. Typically
for an IP Connect configuration, you connect through port 1 (Eth0). (See ‘‘CAT5 cable
connected to a port on the back of the Avaya™ S8700 Media Server’’ on page 216). For a
Multi-Connect configuration, you connect through one of the available 4 ports on the network
interface card (NIC), typically the one corresponding to Eth4.
The other end of the cable connects to an Ethernet switch (router), hub, or token ring.
To Next Page
Loading...
