Avaya S8700 - Install Cables between Media Gateway and MDF; Install Connector Cables between Auxiliary Cabinet and MDF

181
Patch Cord/Jumper Installation and Administration
October 2002
3-Pair Modularity for Trunk Pairs for 3-Pair Tie Trunks
Install Cables Between Media Gateway and MDF
1 Install D rings on the wall between the cable slack manager and the terminal/connecting
blocks mounted on the MDF.
2 Install a self-adhesive port label on the back of each connector on the connector cable.
Position the labels so the media gateway connector retainers do not cover them.
3 At the rear of the media gateway, connect 1 end of the connector cable to the assigned
connector.
4 Route the cable down the rear of the media gateway, through the cable slack manager,
and to the MDF.
5 At the MDF, connect the other end of the cable to the assigned terminal/ connecting
block connector.
6 Store the cable slack in the cable slack manager.
7 Repeat Steps 2 through 6 until all cables are installed.
Install Connector Cables Between Auxiliary
Cabinet and MDF
Auxiliary equipment that connects to the MDF can be mounted inside the Auxiliary cabinet.
The equipment connects to an ED-1E1443-10 (Group 1) intraconnection panel mounted in the
cabinet. This intraconnection panel consists of a 110-type 100-pair wiring block. Auxiliary
Figure notes
1 Green Field
2 1-Pair Jumpers
3 Pairs
4 Purple Field
123456789101112
123456789101112
123456789101112
1716151413 18 19 20 21 22 23 24
3
r758537b MMR 03149
6