239
Installing and Wiring Telephones
October 2002
Installing and Wiring Telephones
The wiring procedures are the same for most Avaya telephones and other equipment.
This task list provides wiring examples of similar installation procedures. These are examples
only; actual wiring procedures may vary at each site.
After installing the hardware, the data for the telephone features must be administered. These
procedures are provided in the Administrator’s Guide for Avaya MultiVantage Software.
NOTE:
Refer to the Installation for Adjuncts and Peripherals for Avaya MultiVantage Solutions to
install the necessary peripheral equipment.
Wiring Telephones
Task List: Wiring Examples and Wiring Procedures
• ‘‘Connect Telephones’’ on page 240
• ‘‘Analog Tie Trunk Example’’ on page 244
• ‘‘Digital Tie Trunk Example’’ on page 245
• ‘‘DS1 Tie Trunk Example’’ on page 246
• ‘‘Auxiliary Connector Outputs (MCC1 and SCC1 media gateways only)’’ on page 249
• ‘‘Three-Pair and Four-Pair Modularity’’ on page 252
• ‘‘Adjunct Power Connection Locations’’ on page 253
• ‘‘Attendant Console Example’’ on page 254
• ‘‘Connect External Alarm Indicators and Auxiliary Power’’ on page 257
• ‘‘Connect Power Distribution Unit External Alarm Wires’’ on page 258
• ‘‘Off-Premises or Out-of-Building Stations’’ on page 261
• ‘‘Emergency Transfer Units and Associated Telephones’’ on page 266
• ‘‘808A Emergency Transfer Panel and Telephone Installation Examples’’ on page 267
• ‘‘Install External Ringing’’ on page 276
• ‘‘Install the Queue Warning Indicator’’ on page 277
• ‘‘Installing and Wiring Telephone Power Supplies’’ on page 278
Refer to the Job Aid entitled Connector and Cable Diagrams (Pinout Charts) for
information on pinouts.
To Next Page
Loading...
