Avaya S8700 - Connect Shorting Cable to J58890 CE-2; Connect AC Power

80
Installing an Avaya MCC1 Media Gateway
October 2002
Connect Shorting Cable to J58890CE-2
!
CAUTION:
For a media gateway with a battery charger, read the caution label on the 397C battery
charger before disconnecting batteries.
Some media gateways contain a J58890CE-2 AC Power Distribution Unit without an optional
battery charger. Install the shorting cable only when a battery charger is not installed. If you do
not install the shorting cable or a battery charger, then an alarm appears.
1 Set the circuit breakers on the power distribution unit OFF. See ‘‘Shorting Cable
Installation’’ on page 80.
2 At the rear of the media gateway, insert the shorting cable (H600-442-G1) into J11. The
cable is keyed so it can fit only 1 way.
Shorting Cable Installation
Figure notes
1 Shorting Cable (H600-442-G1) (if battery charger is not installed)
2 J11
Connect AC Power
1 Set the main circuit breakers on the power distribution unit OFF.
2 Connect media gateway AC line cords to the AC power receptacles.
NOTE:
Do not power up the S8700 Multi-Connect configuration at this time.