116
Installing an Avaya SCC1 Media Gateway Stack
October 2002
Connect Optional Battery Leads
To prevent the internal batteries from discharging, the Control media gateway is shipped with
the battery leads disconnected.
1 Set the circuit breakers OFF. See ‘‘Expansion Control Media Gateway Battery Location
— Right Side’’ on page 116.
2 Connect the battery leads. The battery is near the top of the carrier toward the front-right.
The battery leads are located next to the battery and are accessible from the front of the
media gateway.
Expansion Control Media Gateway Battery Location — Right Side
Figure notes
1 Battery
2 Battery Lead Connector
3 Circuit Breakers (Located Between plates)
4 Media Gateway Single-Point Ground Block
3
4
1
2
4
3 LJK 031096
To Next Page
Loading...
