193
Connect the Hardware
October 2002
Connect the Hardware
This section covers the following tasks:
• ‘‘Connect the Ethernet switch cables to IPSI circuit packs’’ on page 193
• ‘‘Connect Avaya SCC1 media gateway IPSI and maintenance circuit pack ribbon
cables’’ on page 199
• ‘‘Program the IPSI circuit packs’’ on page 205
• ‘‘Using DHCP addressing’’ on page 206
• ‘‘Using static addressing’’ on page 208
• ‘‘Verify connectivity to the media servers’’ on page 211
• ‘‘Avaya MCC1 Media Gateway’’ on page 193
• ‘‘Avaya SCC1 Media Gateway’’ on page 193
• ‘‘Verify connectivity to the media servers’’ on page 211
• ‘‘Verify IPSI firmware version’’ on page 211
• ‘‘Enable control of IPserver interfaces’’ on page 212
• ‘‘Connect the USB Modems’’ on page 212
Connect the Ethernet switch cables to IPSI circuit
packs
Avaya MCC1 Media Gateway
Refer to Getting Started with the Avaya™ S8700 Media Server for Multi-Connect
Configurations for a connectivity guide.
Avaya SCC1 Media Gateway
Refer to Getting Started with the Avaya™ S8700 Media Server for Multi-Connect
Configurations for a general connectivity guide. Use the following detailed steps to
connect the Ethernet cables at the SCC1 media gateway.
1 If not already removed, remove the ground plate. Remove the upper and lower rear
covers from the media gateway(s).
To Next Page
Loading...
