122
Installing an Avaya SCC1 Media Gateway Stack
October 2002
Install Rear Panels
1 Install the rear panels and loosely thread each screw. See ‘‘Rear Panel Screw Locations’’
on page 122.
2 For un-stacked media gateways, tighten the screws securely.
For a stack of media gateways, allow the screws labeled callout 4 to remain loose. These
screws are tightened when the ground plates are installed.
3 Be sure the Time Division Multiplexing (TDM) bus cables and the Inter-Cabinet Cables
(ICC) are not pinched by the panels. Also be sure the cables are routed through the
channels provided on the rear panels.
Rear Panel Screw Locations
Figure notes
1 Expansion Control Media Gateway A (No ground plate is installed on an un-stacked
media gateway)
2 Rear Ground Plate (attached between stacked media gateways)
3 Port Media Gateway B
4 Screws to Loosen
2
1
3
4 4
grnd_plt CJL 030696
To Next Page
Loading...
