219
Connecting to the Customer’s Network
October 2002
NOTE:
The TN799DP circuit packs are hot-swappable, so you do not need to power down the
media gateway to install them.
NOTE:
To properly seat the circuit pack, push firmly on the front of the faceplate until the latch
reaches the bottom rail of the carrier. Then close the latch until it is fully engaged.
1 Insert the TN799DP circuit packs into the port slots identified earlier.
Administer the TN799DP
Use Avaya Site Administration for the administration.
NOTE:
The customer or design team provides the actual names, IP addresses, subnet masks, and
gateway addresses. Refer to the filled-out Job Aid entitled Pre-Installation Network
Worksheet for them.
1 Log in as craft.
2 Type list configuration all and press Enter to verify that the MultiVantage software
recognizes the TN799DP circuit packs.
3 Type change node-names and press Enter.
4 On page 2, type in the node names and IP addresses for each TN799DP C-LAN circuit
pack.
5 Type display circuit-pack and press Enter. Verify that the TN799DP shows up in the
Code column.
6 Type change ip-interfaces and press Enter.
change node-names ip Page 1 of 1
IP NODE NAMES
Name IP Address Name IP Address
csr1clan1 192.168.1 .80 . . .
sr1clan2 172.16 .19 .220 . . .
traf-clan 172.16 .19 .118 . . .
. . . . . .
. . . . . .
. . . . . .
. . . . . .
( 12 of 12 administered node-names were displayed )
Use ’list node-names’ command to see all the administered node-names
Use ’change node-names ip xxx’ to change a node-name ’xxx’ or add a
node-name
To Next Page
Loading...
