Avaya S8700 - Connect High-Reliability CSS-Connected PN1; With 1 Switch Node

96
Installing an Avaya MCC1 Media Gateway
October 2002
Duplex- or High-Reliability CSS-Connected PN1 with 1 Switch Node
Figure notes
1 Media Gateway 1 (PN1 with 1 Switch Node)
2 Port Networks 2 through 16
3 H600-278 Metallic Cable
4 To other port networks
Connect High-Reliability CSS-Connected PN1
with 1 Switch Node
‘‘High-Reliability CSS-Connected PN1 with 1 Switch Node’’ on page 97
shows typical fiber
optic cabling between media gateways. The cable between the EI and SNI on the PN1 media
gateway is a pre-installed metallic cable (H600-278).
Connect the cables between PN1 and each of the other PN media gateways in an alternating port
slot order: 3, 19; 4, 18; 5, 17; and so forth. Media Gateway 1 is PN1 with 1 Switch Node.
B
E
C
D
A
B
E
C
D
A
cadfdup KLC 031202