Avaya S8700 - Cable Installation; Equipment Room Cabling Labels

153
Cable Installation
October 2002
Cable Installation
NOTE:
To route the cables from the rear of the SCC stack or MCC to the MDF, use the ‘‘Install
Cable Slack Managers’’ on page 187 procedure. Also see ‘‘Cable Slack Manager’’ on
page 159.
This section has information about
• ‘‘Equipment Room Cabling Labels’’ on page 153
• ‘‘Cable Routing Guidelines’’ on page 154
• ‘‘Control Carrier Outputs Cable Installation’’ on page 154
• ‘‘Connect Expansion Control Carrier Outputs Cable’’ on page 177
• ‘‘Trunk Cables Among Network Interface, Sneak Fuse Panel, and Media Gateway’’ on
page 155
And procedures for:
• ‘‘Label Expansion Control Carrier Cable’’ on page 177
• ‘‘Connect Expansion Control Carrier Outputs Cable’’ on page 177
• ‘‘Connect Trunk Pairs Using Concentrator Cables’’ on page 178
• ‘‘Connect Trunk Pairs to Media Gateway Using Jumper Wires To Establish 3-Pair
Modularity’’ on page 179
• ‘‘Install Cables Between Media Gateway and MDF’’ on page 181
• ‘‘Install Connector Cables Between Auxiliary Cabinet and MDF’’ on page 181
Equipment Room Cabling Labels
The purple port label shown in ‘‘Equipment Room Cabling Labels’’ on page 155
is installed on
both ends of the 25-pair cables connecting to the trunk/auxiliary field and/or distribution field.
The top blue/yellow building and floor labels are for cables connecting from the equipment
room to a site/satellite location on another floor or in another building. The yellow label is for
auxiliary circuits connecting to the trunk/auxiliary field. The bottom blue/yellow label is for
25-pair cables connecting to site/satellite closets.
‘‘Equipment Room Labels’’ on page 155
details the label name and range of each label.
‘‘Cable/Connector/Building Label Ordering Information’’ on page 156
provides label ordering
information.
‘‘Self-Stick Label on 25-Pair Cable Connector’’ on page 156
shows the proper way to install a
label on a 25-pair cable connector. Install the label near the rear of the connector so it is not
obscured by the media gateway connector retainers. It can also be installed on the skin of the
cable near the connector.