Avaya S8700 - Page 13

13
Installing the S8700 Multi-Connect
Contents
October 2002
Install Telephones Used for Emergency Transfer
and as Normal Extension (Trunk/Auxiliary Field) 275
Install External Ringing 276
Install the Queue Warning Indicator 277
• Installing and Wiring Telephone Power Supplies 278
1145B22 Power Supply 278
Important Warning for 1145B2 Power Supply 278
Mounting the 1145B2/1146B2 Power Supply 280
Install the Wall-Mounting Plates 282
Mount the 1146B2 Power Distribution Unit 283
Install the Battery Mounting/Wiring 283
Install the Expanded Power Distribution Unit 284
Power Up and Test the Power Supply 285
Wire the 1146B2 Power Distribution Unit 285
Reset LEDs on Power Distribution Unit 286
1151A1 and 1151A2 Power Supplies 287
Important Safety Instructions for 1151A1 and
1151A2 Power Supplies 287
Using 1151A1 and 1151A2 Power Supplies 288
Connect the 1151A1 or 1151A2 Power Supplies 288
P333T-PWR Power over Ethernet Stackable Switch 289
P333T-PWR switch Important Safety Instructions 289
Using the P333T-PWR switch 290
Connect the P333T-PWR switch 291
• Completing the Installation Administration 293
Verify translations 293
View alarms 293
Upgrade the IPSI firmware (if necessary) 294
Enable and disable Ethernet switch ports 294
Back up the media server to PCMCIA flashcard 295
Release busied out media server 296
View alarms 296
Add INADS phone numbers 297
Enable alarms to INADS via modem 297
Enable alarms to INADS via SNMP 297
Register the system 298
• Accessing the Avaya S8700 Media Server 299
Accessing the Avaya S8700 Media Server Directly 299
Media Server Web Interface 300