189
Patch Cord/Jumper Installation and Administration
October 2002
2 Hold the panel against the mounting surface and mark the mounting screw locations.
Drill pilot holes at the marked locations and partially install a locally obtained #12 x
3/4-inch screw into the two bottom mounting slots.
3 Slide the sneak fuse panel onto the mounting screws and tighten the screws securely.
4 Install a locally obtained #12 x 3/4-inch screw into the top two mounting slots and
tighten securely.
5 Repeat the procedure for each sneak fuse panel.
6 Secure the B25A cable to the panel with the captive screw on the connector and a
supplied cable tie.
Model 507B Sneak Fuse Panel
Figure notes
1 Sneak Fuse Panel
2 25-Pair Male Connector (In)
3 25-Pair Female Connector (Out)
4 220029 Fuses (Inside Panel). Use
small screwdriver to pry top cover off.
Sneak Fuse Connector Pinout
Connector Pin Numbers Pair/Fuse Number
26/1 1
27/2 2
28/3 3
29/4 4
30/5 5
Sneak
Current
Protector
507B
sneak CJL 032096
To Next Page
Loading...
