210
Connect the Hardware
October 2002
NOTE:
The craft login used on the IPSI has a different password than the craft login used on the
media servers.
7 Log in as craft.
Prompt = [IPADMIN]:
8 Type set control interface <ipaddr><netmask>, where <ipaddr>is the
customer-provided IP address and <netmask> is the customer provided subnet mask.
Press
Enter.
9 Type show control interface. Press Enter.
The IP address, subnet mask, and default gateway information will be displayed.
Verify that the proper information was entered.
10 If required type set control gateway <gateway>, where <gateway> is the
customer-provided IP address for their gateway. Press
Enter.
11 If required use the set vlan priority, set vlan tag, set vlan id and set diffserv commands
to enter VLAN and diffserv parameters for the IPSI. Use the help <command> to obtain
syntax guidelines for these commands.
12 Type reset. Press Enter
Answer Y to the warning.
To Next Page
Loading...
