39
Configure Media Server 1
October 2002
Refer to the filled-out job aid entitled Pre-Installation Network Planning Forms—S8700 Media
Server for information on how to access a computer on the customer’s network.
1 Connect a customer-supplied CAT5 straight-through cable from media server 1, port 4
(Eth4), to the customer’s LAN. Refer to Getting Started with the Avaya™ S8700 Media
Server with MCC1 or SCC1 Media Gateway.
NOTE:
For security reasons, you may not be able to ping out to the customer’s network. If you are
not able to, look at the LAN security settings, particularly icmp.
2 Under Security click Set LAN Security
3 If icmp is not checked, check both boxes to the left and click Set Security.
To Next Page
Loading...
