75
signal.
Video Loss On: Outputs an alarm signal when a video loss occurs in the specified video input terminal.
Alarm Duration: Sets the duration of the alarm output signal
Error Alarm: Sets whether to output or not an alarm signal when the error condition occurs.
(Options are OFF, ALL, HDD ERROR and VIDEO LOSS.)
SUBMIT: Save surely by pressing this button after setting the value.
9-7-3-3. PTZ
Setting the PTZ Control: Sets the communication environment for remotely operating PTZ dome cameras
connected to RS485 terminals.
Camera channel designation
Name: Sets the protocol type for the specified channel. When connecting multiple cameras, set the same
protocol for all.
Speed: Sets the communication speed. The set value applies to all channels.
ID: Sets the camera ID.
SUBMIT: Save surely by pressing this button after setting the value.
To Next Page