Banner Q5X - Gain and Sensitivity (GAin); Output Timing Delays

July 25, 2023
Q5X With Dual Discrete Outputs And IO-Link Instruction Manual


20
•
•
•
•
•
•
•
•
•
2000 mm Models
ResponseSpeed ResponseSpeedinSyncMode Repeatability AmbientLightRejection ExcessGain
3ms 6ms 1000µs Disabled
SeeExcessGainin"Q5XDualDis
crete with IO-Link Specifications" on
page 39
5ms 10ms 1600µs Enabled
15ms 30ms 3ms Enabled
25ms 50ms 5ms Enabled
50ms 100ms 10ms Enabled
5000 mm and 10000 mm Models
ResponseSpeed ResponseSpeedinSyncMode ExcessGain
2ms 4ms
SeeExcessGainin"Q5XDualDiscretewithIOLinkSpec
ifications" on page 39
5ms 10ms
15ms 30ms
50ms 100ms
250ms 500ms
Gain and Sensitivity (GAin)
Usethismenutosettheexcessgainmode.
For2000mmmodels—Thismenuisonlyavailablewhena15,25,or50millisecondresponsespeedisselected.Itisnot
available for 3 or 5-millisecond response speeds.
—Highexcessgainmode
—Standardexcessgainmodewithincreasednoiseimmunity
For5000mmmodels—
—Performancegainmodeprovidesthebestperformanceonthetypicalrangeofdarktoshinytargets
—Blackgainmodeprovidesthemaximumexcessgainandbestperformancewhenlookingatextremelydark
targetswithlittlereflectivity
—Shinygainmodeprovidesthebestperformancewhenlookingatextremelyreflectivesurfaces.
Output Timing Delays
Usethismenutoselecttheoutputtimingdelaytobeset.
Onandoffdelaytimerscanbeusedtogether.Thedefaultisnodelay.For Channel 2, this menu is available when the output
is set to light operate or dark operate.
NOTE: ThenumberthatfollowsdLYonthedisplayindicateswhichchannelisselected.
—Nodelay
—Delay—enablestheselectionofonandoffdelaytimers
—Oneshot—enablesaoneshot,fixedoutputpulseduration
—Totalizer—enablesanoutputafteradefinednumberoftargetsarecounted
© Banner Engineering Corp.