Banner Q5X - Reset to Factory Defaults Using the Remote Input; Locking and Unlocking the Sensor Buttons; Button Instructions; Remote Input Instructions

July 25, 2023
Q5X With Dual Discrete Outputs And IO-Link Instruction Manual


28
•
•
•
ResettoFactoryDefaultsUsingtheRemoteInput
FollowtheinstructionsbelowtoresettheQ5XtofactorydefaultsusingRemoteInput.
EightpulsetheremoteinputtoapplythefactorydefaultsandreturntoRunmode.
The input wire function remains at remote teach input (SEt).
Locking and Unlocking the Sensor Buttons
Usethelockandunlockfeaturetopreventunauthorizedoraccidentalprogrammingchanges.
Three settings are available:
—Thesensorisunlockedandallsettingscanbemodified(default).
—Thesensorislockedandnochangescanbemade.
—Theswitchpointvaluecanbechangedbyteachingormanualadjustment,butnosensorsettingscanbe
changedthroughthemenu.
WhenthesensorisineitherLocor0Locmode,theactivechannelcanbechangedusing(+)(CH1/CH2).
WheninLocmode,Locdisplayswhenthe(SELECT)(TEACH)buttonispressed.Theswitchpointdisplayswhen(+)(CH1/
CH2)or(-)(MODE)arepressed,butLocdisplaysifthebuttonsarepressedandheld.
Whenin0Locmode,Locdisplayswhen(-)(MODE)ispressedandheld.Toaccessthemanualadjustoptions,brieflypress
andrelease(+)(CH1/CH2)or(-)(MODE).ToenterTEACHmode,pressthe(SELECT)(TEACH)buttonandholdforlonger
than2seconds.
Button Instructions
To enter Loc mode, hold + and press - four times. To enter 0Loc mode, hold + and press - seven times. Holding + and press
ing - four times unlocks the sensor from either lock mode and the sensor displays uLoc.
Remote Input Instructions
Continued from page 27
Action
Result
Pulses  TEACHMode
5
T T
T
T
T
T
T
T
T

Dual(intensity+distance)
Access the remote input.
Action Result
Fourpulse the remote input.
T T
T T T
T T
The sensor is ready to have the button state
defined and btn displays.
1.
Lock or unlock the sensor buttons.
Action Result
Singlepulse the remote input to unlock the sensor.
T
uLoc displays and the sensor returns to
Run mode.
Continued on page 29
2.
© Banner Engineering Corp.