Banner Q5X - Delay Timers (ond1, ond2, oFd1, oFd2, dt1, dt2); Totalizer (totL)

July 25, 2023
Q5X With Dual Discrete Outputs And IO-Link Instruction Manual


21
•
•
•
•
•
•
•
•
•
Output Timing Delays
Output
OFF Delay
ON Delay
Time
1-Shot
ON
OFF
D
D
D
D
D D
(D = 1ms - 90.0s)
Whenoneofthetimingdelayoptionsischosen,thesensorreturnstotheSetupmenuandadditionaloptionsbecomeavail
abletosettheparameter(s):
—Ondelay
—Offdelay
/ —Oneshotdelaytimer
NOTE: For the one-shot delay timer:
LO=Onpulsewhenatargetisdetectedinsideoftheswitchpoint(s)
DO=Onpulsewhenatargetisdetectedoutsideoftheswitchpoint(s)
/ —Outputduration
/ —Numberofcountsbeforeanoutputchange
DelayTimers(ond1,ond2,oFd1,oFd2,dt1,dt2)
Usethesemenustosetthedelaytimers.
Thesemenusareavailableonlyifanoutputtimingdelayisselected.
ForandandoFd,thedefaultis0.
Fordt1,thedefaultis10millisecondsforallresponsespeeds
Use+and-toscrollthroughthevalues.Millisecondvaluesdonotincludethedecimalpoint;secondsvaluesincludethedec
imal point.
1to999ms(whendt1isselected,the1to9msrangeisavailablefor3and5msresponsetimes)
1.0to90.0s
Totalizer (totL)
Thetotalizerfunctionchangestheoutputonlyaftercountingadesignatednumberoftargets.
Afterselectingthisfunction,dt1ordt2becomeavailabletodefinetheoutputdurationandtot1ortot2todefinetherequired
numberofcountsbeforetheoutputchanges.
Fortot1andtot2,thedefaultis1countandthemaximumis9999counts.
Fordt1anddt2,thedefaultis10milliseconds.Use and toscrollthroughthevalues.Valuesinmillisecondsdonotin
clude the decimal point; values in seconds include the decimal point.
© Banner Engineering Corp.