Banner Q5X - Dynamic Background Suppression (dYn)

July 25, 2023
Q5X With Dual Discrete Outputs And IO-Link Instruction Manual


30
See"Q5X Dual Discrete with IO-Link Performance Curves" on page 43fortheminimumobjectseparation.
Expected TEACH Behavior for Two-Point Static Background Suppression
Condition TEACHResult Display
Two valid distances that are greater than or
equaltothehorizontalminimumobjectsepa
ration
Setsaswitchpointbetweenthetwotaughtdistances.
Theswitchpointdistanceflashesonthedis
play.
Two valid distances that are less than the
horizontalminimumobjectseparation
Sets a switch point in front of the furthest taught distance
equaltotheuniformreflectivityminimumobjectsepara
tion.
bGSandtheswitchpointdistanceflashal
ternatelyonthedisplay.
One valid distance with one invalid TEACH
point
Sets a switch point between the one taught distance and
themaximumrange.
obJtandtheswitchpointdistanceflashalter
natelyonthedisplay.
TwoinvalidTEACHpoints
Setsaswitchpointforthecurrentlyselectedchannelat
197cm.
FuLLandtheswitchpointdistanceflashal
ternatelyonthedisplay.
Dynamic Background Suppression (dYn)
Dynamic TEACH sets a single switch point during machine run conditions.
Dynamic TEACH is recommended for applications where a machine or process may not be stopped for teaching.The sensor
takes multiple samples and the switch point is set between the minimum and the maximum sampled distances.
Continued from page 29
Method Action Result
Remote Input Noactionrequired.  N/A
Teach the sensor.
Method Action Result
Push Button PressTEACHtoteachthetarget.
Thesensoristaughtthefirsttar
get.SEt,2nd, and the current distance
measurementflashalternatelyonthedis
play.The DYN, FGS, and BGS indicators
flash.
Remote Input Singlepulsetheremoteinput.

T

3.
Present the target.
Method Action Result
Push Button
Present the second target. The sensor-to-target distance must be within the
sensor'srange.
SEt,2nd, and the distance measurement
flashalternatelyonthedisplay.The DYN,
FGS, and BGS indicators flash.
Remote Input
4.
Teach the sensor.
Method Action Result
Push Button PressTEACHtoteachthetarget.
The new switch point flashes rapidly and
thesensorreturnstoRunmode.
Remote Input Singlepulsetheremoteinput.

T

5.
© Banner Engineering Corp.