Basler A504k - Page 126

iv Basler A500k Series
PRELIMINARY
ming 2 3-20
ExSync, programmable mode with synchronous/
asynchronous timing 3-18
F
factory set
copying to the work set 4-25
explained 3-41
fill factor 1-2
firmware versions
reading with binary commands 4-23, 4-24
flash trigger receptacle 2-6
flash trigger signal 2-22
explained 2-22
high side switch 2-7, 4-20
low side switch (open collector) 2-7, 4-20
TTL 2-7, 4-20
with binary commands 4-20
FlashCtrl 4-20
FlashCtrl register 4-20
FlashOut 2-22
F-mount adapter 5-3
FPGA firmware version
viewing with commands 4-24
frame counter 3-36
frame rate
changes with area of interest 3-35
spec 1-2
free-run
explained 3-5
setting with binary commands 4-11
free-run mode with asynchronous timing 3-21
free-run mode with synchronous / asynchronous ti-
ming 3-22
free-run mode with synchronous timing 1 3-23
free-run mode with synchronous timing 2 3-24
free-run SXGA mode 3-25
free-run, programmable exposure mode
explained 3-5
free-run, SXGA mode
explained 3-6
functional description
camera 3-1
G
gain
explained 3-29
setting with binary commands 4-14
H
high side switch 2-7, 4-20
humidity requirements
camera 1-6
I
input signals
to the camera 2-12
interfacing the camera 2-1
IR cut filter 3-28
K
k-BIC 2-24
Kdrk 1-2
L
LED 6-1
on the camera 2-25
level-controlled exposure mode
explained 3-4
line valid bit 2-13
long exposure compensation
explained 3-26
setting with binary commands 4-13
low side switch 2-7, 4-20
M
MDR 26 Camera Link connector 2-3
model number
viewing with commands 4-22
model tab 4-4
mounting facilities 5-1
O
offset
explained 3-29
offset, negative
setting with binary commands 4-14
offset, positive
setting with binary commands 4-15
open collector 2-7, 4-20
output data rate 1-2
output mode
see video data output mode(s)
output signals
from the camera 2-13
P
photo response non-uniformity 1-2
pin assignments
camera 2-3, 2-8
pin numbering
camera 2-3
pixel clock
on the camera 2-13
pixel clock speed 1-2
pixel depth 1-2
pixel size 1-2
positioning accuracy of the sensor chip 5-4