AW00123409000 Features
Basler ace USB 3.0 219
1)
Parameter is only available for color cameras.
2)
Parameter is not available for acA2000-165uc and acA2040-90uc cameras.
3)
Parameter is only available for use with the sequencer if the Gamma parameter value is set
to 1 or if no light source preset is selected.
4)
Parameter is not available for use with the sequencer for the following cameras: acA1920-40,
acA1920-155, acA2000-165, acA2040-55, acA2040-90, acA2040-120, acA2440-35, and
acA2440-75.
5)
Parameter is only available for the following cameras: acA640-750, acA800-510,
acA1300-200, acA1920-40, acA1920-150, acA1920-155, acA2000-165, acA2040-55,
acA2040-90, acA2040-120, acA2440-35, and acA2440-75.
7.7.2.2 Sequencer Set Related Parameters and Sequencer Set
Advance
Sequencer Set Related Parameters
To each sequencer set the parameter values for the following sequencer set related parameters
apply.
The Sequencer Set Start parameter defines the first sequencer set that will be loaded into the
active set after the following two actions have occurred:
the sequencer mode was set to On and
the first frame start trigger was issued.
For all Basler USB 3.0 ace cameras, the Sequencer Set Start parameter value must always be
set to 0. This selects sequencer set 0 as the first sequencer set to be loaded and used for an
image acquisition.
The Sequencer Set Selector parameter selects a sequencer set by its index number. Selecting
a sequencer set is necessary when configuring a sequencer set (see Section 7.7.3 on
CounterDuration (for Counter 2) TimerDelay (for Timer 1)
CounterEventSource TimerDuration (for Timer 1)
CounterResetSource Width
SequencerSetStart CounterEventSource
SequencerSetSelector CounterResetSource
SequencerSetPath CounterDuration (for Counter 2)
SequencerSetNext
SequencerTriggerSource
SequencerTriggerActivation
To Next Page
Loading...
Need help?
General
