Features AW00123409000
340 Basler ace USB 3.0
7.23.3.2 Line Status All Chunk
The line status all chunk feature adds a chunk to each acquired image containing the line status all
parameter value
1. Use the Chunk Selector to select the Line Status All chunk.
2. Use the Chunk Enable parameter to set the value of the line status all chunk to true.
Once the line status all chunk is enabled and Chunk Mode Active (see Section 7.23.4 on page 347)
is enabled, the camera appends a line status all chunk to each acquired image.
After an image with an appended chunk has been received by your computer the chunk must be
retrieved. For information about retrieving data chunks, see Section 7.23.5 on page 348.
You can set the Chunk Selector and Chunk Enable parameter value from within your application
software by using the Basler pylon Camera Software Suite. The following code snippet illustrates
using the API to activate the chunk mode, select the line status all chunk, and enable the line status
all chunk:
// make chunk mode active, select and enable Line Ststus All chunk
camera.ChunkSelector.SetValue(ChunkSelector_LineStatusAll);
camera.ChunkEnable.SetValue(true);
You can also use the Basler pylon Viewer application to easily set the parameters.
For more information about the pylon Camera Software Suite and the pylon Viewer, see Section 3.1
on page 61.
To enable the line status all chunk:
To Next Page
Loading...
Need help?
General
