AW00123409000 Tools for Changing Camera Parameters
Basler ace USB 3.0 61
3 Tools for Changing Camera
Parameters
3.1 Basler pylon Camera Software Suite
The Basler pylon Camera Software Suite is designed to operate all Basler cameras that have an
IEEE 1394a/b interface, a GigE interface or a USB 3.0 interface. The Basler pylon Camera Software
Suite will also operate newer Basler camera models with a Camera Link interface.
The pylon camera drivers offer reliable, real-time image data transport into the memory of your
computer at a very low CPU load.
The options available with the Basler pylon Camera Software Suite let you
change parameters and control the camera by using a standalone GUI known as the Basler
pylon Viewer.
change parameters and control the camera from within your software application using the
Basler pylon SDKs.
obtain information about the USB camera device and other USB devices connected to your
host computer by using the Basler pylon USB Configurator.
The remaining sections in this chapter provide an introduction to the tools.
3.1.1 pylon Viewer
The pylon Viewer is included in the Basler pylon Camera Software Suite. It is a standalone
application that lets you view and change most of the camera’s parameter settings via a GUI. Using
the pylon Viewer is a very convenient way to get your camera up and running quickly during your
initial camera evaluation or a camera design-in for a new project.
For more information about using the pylon Viewer, see the Installation and Setup Guide for
Cameras Used with Basler pylon for Windows (AW000611).
To Next Page
Loading...
Need help?
General
