Features AW00123409000
316 Basler ace USB 3.0
Setting Your System for Event Notification
Event notification must be enabled in the camera and some additional software-related settings
must be made. This is described in the "Camera Events" code sample included with the pylon
software development kit.
Event notification must be specifically set up for each type of event using the parameter names of
event and supplementary information. The following table lists the relevant parameter names:
l
* Only available for acA640-750u, acA800-510u, acA1300-200u, acA1920-40u, acA1920-150u,
acA1920-155u, acA2040-55u, acA2040-120u, acA2440-35u, acA2440-75u, and acA2500-60u
cameras.
You can enable event notification and make the additional settings from within your application
software by using the pylon API. The pylon Camera Software Suite includes a
"Grab_CameraEvents" code sample that illustrates the entire process.
For more detailed information about using the pylon API, refer to the Basler pylon Programmer’s
Guide and API Reference.
Event Event Parameter Name Supplementary Information
Parameter Name
Frame Start EventFrameStart EventFrameStartTimestamp
Frame Start Overtrigger EventFrameStartOvertrigger EventFrameStartOvertriggerTimestamp
Frame Start Wait EventFrameStartWait EventFrameStartWaitTimestamp
Frame Burst Start EventFrameBurstStart EventFrameBurstStartTimestamp
Frame Burst Start
Overtrigger
EventFrameBurstStartOvertrigger EventFrameBurstStartOvertriggerTimestamp
Frame Burst Start Wait EventFrameBurstStartWait EventFrameBurstStartWaitTimestamp
Exposure End EventExposureEnd EventExposureEndFrameID
EventExposureEndTimestamp
Critical Temperature* EventCriticalTemperature EventCriticalTemperatureTimestamp
Over Temperature* EventOverTemperature EventOverTemperatureTimestamp
Table 57: Parameter Names of Events and Supplementary Information
To Next Page
Loading...
Need help?
General
