Revision History AW00123409000
358 Basler ace USB 3.0
AW00123407000 21 May 2016 cont’d
Added Section 7.2.1 on page 193 to explain analog and digital GainAll
control.
Indicated conditions in Section 7.7.2.1 on page 218 for including
LUTEnable in sequencer operation.
Indicated different trigger source availabilities of trigger sources for
sequencer paths 0 and 1 in Section 7.7.2.2 on page 219.
Changed parameter name "Device ID" to "Device Serial Number" in
Section 7.19 on page 322.
AW00123408000 06 Jul 2016 Added information for the following new cameras: acA2040-55u,
acA2040-120u, acA2440-35u, and acA2440-75u throughout the manual.
Updated the max. frame rates for acA1920-150u and acA2500-60u
cameras in Section 1.3.2 on page 8.
Added Section 5.9.2 on page 79 about setting the line mode for a GPIO
line.
Modified the exposure time offset values for acA1920-40u and
acA2040-90u cameras in Section 6.4.3.2 on page 129.
Added a section about RGB8 and BRG8 in Section 7.14.1.2 on page 275.
Added the frame start wait and frame burst start wait events in
Section 6.8.5 on page 173 and Section 7.17 on page 314.
Added the Color Raw user set in Section 7.21 on page 327.
Rearranged information in Section 7.23 on page 338.
AW00123409000 18 Nov 2016 Replaced "special conditions" in Section 1.3.2 on page 8 by "HiDLTL" and
explained them in Section 1.2 on page 2.
Indicated conformities with REACH in Section 1.3 on page 4.
Corrected the optical size for acA80-510u cameras in Section 1.3.2 on
page 8.
Removed the availability of the CS-mount for the acA3800-14u camera in
Section 1.3.2 on page 8.
Added Section 1.4 on page 24.
Updated activation temperatures in Section 1.11.3 on page 51.
Changed TemperatureState parameter value from Normal to OK in
Section 1.11.3.2 on page 55.
Added order numbers in Section 1.12 on page 56.
Added a note not to change trigger mode during acquisition in
Section 6.3.5.2 on page 121 and Section 6.4.1.3 on page 131.
Added a note not to change shutter mode during acquisition in
Section 6.6.2.2 on page 148.
Indicated the unavailability of exposure time chunks when operating in
trigger width exposure mode in Section 6.4.3.2 on page 129 and
Section 7.23.3.3 on page 341.
Mentioned fast sensor readout mode, removal of bandwidth limit, and
connections of more than one camera to a host inSection 6.10 on
page 178.
Doc. ID Number Date Changes
To Next Page
Loading...
Need help?
General
