Specifications, Requirements, and Precautions AW00123409000
58 Basler ace USB 3.0
NOTICE
An incorrect plug can damage the 6-pin connector:
The plug on the cable that you attach to the camera’s 6-pin I/O connector must have 6
female pins. Using a plug designed for a smaller or a larger number of pins can damage the
connector.
The plug on the cable that you attach to the camera’s USB 3.0 Micro-B port must be
designed for use with the USB 3.0 Micro-B port. Trying to use any other type of plug can
destroy the port.
NOTICE
Cleaning of the sensor:
Avoid claning the surface of the camer’s sensor if possible. If you must clean it:
Before starting, disconnect the camera from camera power and I/O power.
Use a soft, lint-free cloth dampened with a small amount of window cleaner.
Because electrostatic discharge can damage the sensor, you must use a cloth that won’t
generate static during cleaning (cotton is a good choice).
Make sure the window cleaner has evaporated after cleaning, before reconnecting the
camera to power.
Cleaning of the housing:
Before starting, disconnect the camera from camera power and I/O power.
Use a soft dry cloth. To remove severe stains, use s soft cloth dampened with a small
quantity of detergent, then wipe dry.
Because electrostatic discharge can damage the camera, you must use a cloth that won’t
generate static during cleaning (cotton is a good choice).
Do not use solvents or thinners. They can damage the surface finish.
To Next Page
Loading...
