Baumuller b maXX 5000 Series - Page 229

Troubleshooting and Fault correction
Instruction handbook b maXX 5000
Document No.: 5.09021.16
229
of 328
10
Overload monitoring
6)
Peak current not possible at this time X - - - -
Heat sink temperature Temperature > threshold 1 X - X - -
Temperature > switch-off threshold - X - - X
Internal temperature 
of device
6)
Temperature > threshold 1 X - X - -
Temperature > switch-off threshold - X - - X
Motor temperature
6)7)
I
2
t threshold exceeded - X - - X
Threshold 1 exceeded
2)
X - X - -
Threshold 2 exceeded
2)
X - X - -
Sensor short circuit and/or 
temperature < -30 °C
2)
- X - - -
Sensor not connected and/or 
temperature > 250 °C
2)
- X - - -
Maximum temperature exceeded
2)
- X X - X
Position controller
6)7)
Dynamic position deviation - X X X -
Static position deviation - X X X -
Encoder 1
6)7)
Cable break
(square-wave incremental encoder)
- X X X
4)
Cable break (SIN
2
+ COS
2
) - X X X
4)
Overspeed - X X X
4)
Encoder 2
6)7)
Cable break
(square-wave incremental encoder)
- X X X
4)
Cable break (SIN
2
+ COS
2
) - X X X
4)
Overspeed - X X X
4)
Monitoring function Warning/error
Warning Error Adjustable threshold Adjustable reaction Reaction inhibit pulses
1)
Pulses are inhibited after a adjustable time period (not provided for BM51XX).
2)
Only if KTY/PT1000 sensors are used
3)
Threshold adjustable
4)
Reaction adjustable
5)
Not provided for BM53XX
6)
Not provided for BM50XX
7)
Not provided for BM51XX
8)
Only provided for BM51XX
9)
Not processed by BM51XX, only a message for the axis units.
X: Implemented
-: Not possible