Bender ISOMETER iso1685DP-425 - Channel Configuration; Channel Name; EDS Outputs

Settings
59
isoxx1685Dx-x25_D00272_07_M_XXEN/09.2022
8.2 (2.5) Channel
In this menu, each channel can be configured. See also chapter 8.2 (2.4.1) "Channel”.
8.2 (2.5.1) Name
Enter a name for the selected channel. This name will also be displayed on the gateways and
in the web server and can be edited via these as well.
8.2 (2.5.2) CT monitoring
See chapter 8.2 (2.4.1.2) "CT monitoring”.
8.2 (2.5.3) Response value I
∆L
See chapter 8.2 (2.4.1.3) "Response value I∆L”.
8.2 (2.5.4) Response value I
∆n
See chapter 8.2 (2.4.1.4) "Response value I∆n”.
8.2 (2.6) Outputs
In this menu, each output can be configured. See also chapter 8.2 (2.4.2) "Outputs”.
8.2 (2.6.1) Common relay
Select the relays to be configured.
8.2 (2.6.1.1) TEST
See chapter 8.2 (2.4.2.1.1) "TEST”.
8.2 (2.6.1.2) Relay mode
See chapter 8.2 (2.4.2.1.2) "Relay mode”.
8.2 (2.6.1.3) Function 1
See chapter 8.2 (2.4.2.1.3) "Function 1”.
8.2 (2.6.1.4) Function 2
See chapter 8.2 (2.4.2.1.3) "Function 1”.
8.2 (2.6.1.5) Function 3
See chapter 8.2 (2.4.2.1.3) "Function 1”.
8.2 (2.6.2) Channel relay
Select the relay to be configured.
•Select all All relays are selected.
•No selection No relay is selected.
•Invert selection The current selection is inverted.
•Relay 1 (BS 2/1) A single relay is selected.
•Relay 2 (BS 2/2)
•Relay 1 (BS 2/1)
...