14
Multifunction Control Panel
Superkeys
If your Installer has set up the 3 Superkeys (, and ), you will be able to
operate your system from the keypad, without using Codes. The ‘Superkeys’ can
be programmed to activate:
z the Digital Communicator – to transmit event codes to the Central Station
Up to 8 Telephone numbers can be programmed for these commands.
z the Dialler – to send a voice message (requires NC2/VOX Voice board). Not
management for KYO16D Control Panel.
Up to 8 Telephone numbers can be programmed for these commands.
z One or more Outputs
A long beep will confirm that the selected facility has been activated.
7URXEOH 'HVFULSWLRQ
!"
#
$%& #
'%
#(=(!)*'(+%,-("
.#
##/''
+$'0$1
$#
'$%&
%#(
=
(!)*'
(%,-("
The Keypad Buzzer will emit an audible signal each time a valid key is pressed
and,
if enabled by your Installer, will also signal:
z The Exit Time (signalled by slow beeps)
z The Entry Time (signalled by fast beeps)
z Errors or Invalid requests (signalled by a Buzz)
z Request Accepted or Done (long beep)
z Violation of a ‘Chime’ zone
z Key/Card programming done
z Auto-arm Timeout
Buzzer
To Next Page
Loading...
