47
Operating the System from a Telephone
Press
to confirm the selected status and step back.
Press
to exit.
Arm / Disarm
Press
to access Arm/Disarm management.
This following keys will allow you to Arm / Disarm the system as required.
Ö The system will Disarm
Ö The system will Arm in Global mode
Ö The system will Arm A Mode
Ö The system will Arm B Mode
After pressing the required key (as above), the system will wait for you to end
the communication.
Press
to end the call.
For further information, refer to the next ‘System Status Enquiry’ paragraph.
System Status Enquiry
To make a system status enquiry, press key
(to access Arm/Disarm manage-
ment) then press
: the Control panel will signal the status as follows:
1 buzz Ö Disarmed
1 beep Ö Armed in Global Mode
2 beeps Ö Armed in A Mode
3 beeps Ö Armed in B Mode
3 buzzes Ö Arming Mode “Not Recognised” — this occurs when the Con-
trol panel has been Armed by a User Code with a different configuration to
the one making the enquiry.
System status enquiries and response signals DO NOT effect the System status.
To Next Page
Loading...
