Bentel Security KYO 4M User Manual

16
Multifunction Control Panel

To Arm the system in ‘Global’ mode — enter a Main User, User or Panic Code,
then press
ON.
If your Installer has enabled the Quick Arm feature, you will be able to Arm the
system from the keypad without using an Access Code, as follows:
1a.
Press and hold the ON key for 3 seconds.
2a. Release the key after the audible signal (long beep), the system will Arm
the Keypad Partitions (as programmed by the Installer). This operation will
take about 2 seconds (the Keypad will emit an audible signal when the system
Arms).
To Arm a specific partition only:
1b. Enter the partition ID Number, then press ON,
the keypad will emit an
audible signal when the partition Arms.
Global Disarming (Code + OFF)
This command will Disarm all the partitions controlled by the Code and keypad
concerned.
To Disarm the system in ‘Global’ mode — enter a Main User, User, Panic or
Duress Code, then press
OFF.
The Duress code will disarm the system and trigger the Digital communicator.
If
your installer has set up your system to manage the Digital communicator facility, the
Digital communicator will send a voice message to the Central Station.
If the system is disarmed by a ‘Duress’ code, the keypads will remain mute.
A or B Mode Arming (Code + A or Code + B)
This command will Arm/Disarm the partitions controlled by the Code concer-
ned. During the programming phase, the User Codes will be configured for Stay/
Away arming (A or B Mode). The programmed configuration determines the par-
titions which will Arm/Disarm when you make an A or B Mode Arming request.
To Arm the system in A or B Mode — enter a Main User, User or Panic Code,
then press
A (A Mode) or B (B Mode).
If your Installer has enabled the Quick Arm feature, you will be able to Arm the
system in A or B Mode from the keypad without using an Access Code, as fol-
lows:
1. Press and hold the
ON key for 3 seconds.
2. Release the key after the audible signal (long beep), press
A or B (A or B
Mode), as required.
If you do not press A or B within 2 seconds, the system will Arm the
keypad partitions (as programmed by the Installer).
Example: A Mode Arming configuration = Arm partitions 1 and 4; Disarm
partitions 2 and 3.
Quick Arm:
A or B Mode
Disarm under Duress
Quick Arm
Keyboard Partitions
Specific Partition

Bentel Security KYO 4M Specifications

General

Brand	Bentel Security
Model	KYO 4M
Category	Control Unit
Language	English